If a drip line stays clogged after you clean the drip holes, calcium scaling or debris has built up inside it. Attach the line directly to the pump in a bin of water, and the force of the water will blast it out.
How to Identify the Issue
Water flow to the plants is poor, rockwool plugs appear dry, or one or both driplines are clogged even after cleaning the drip holes.
What is Happening?
Calcium scaling or debris has built up inside the drip line, blocking water flow.
Prevention Steps
Every 2 weeks, clean and flush the drip lines following Weekly Flex Farm Maintenance Checklist to keep water flowing smoothly and prevent clogs.
Resolution Steps
- Unplug the pump.
- Take off the top caps and remove the drip lines from the Root Chamber notches.
- Remove the left and right drip lines from the Y-joint by pulling the tubing off.
- Remove the vertical irrigation line from the pump and take the pump out of the tank.
- Fill a large garbage bin, utility sink, or a 5-gallon bucket with enough water to fully submerge the pump. (Note: If using a bucket, do this outside, as water will spray powerfully).
- Place the pump in the water and attach the clogged dripline directly to the pump.
- Open the front ball valve of the dripline to maximize flow.
- Plug the pump into a GFCI-protected outlet, keeping the plug and cord dry, and make sure the drip line holes are aimed into the bin/sink. The force of the water will blast any scaling or debris out of the dripline.
- Once cleared, unplug the pump and reassemble the farm. To prevent future clogs, clean and flush the drip lines every 2 weeks.
Related articles